Repair Engineered Wood Floor Water Damage

When water damages engineered wood flooring, it is important to act quickly to minimize the damage and prevent further issues. The following steps will help you repair engineered wood floor water damage:

1. Stop the water source: If the water is still flowing, stop it by turning off the water supply or fixing the leak. If the water has already stopped, remove any standing water from the floor with a wet vacuum or towels.

2. Remove the damaged planks: Once the water has been removed, you need to remove the damaged planks. Use a pry bar to carefully pry the planks loose from the subfloor. Be careful not to damage the subfloor.

3. Dry the subfloor: Once the damaged planks have been removed, you need to dry the subfloor. Use a fan or dehumidifier to circulate air and dry the subfloor. You may also need to use a wet vacuum to remove any remaining water.

4. Repair the subfloor: If the subfloor has been damaged, you will need to repair it before you can install new planks. This may involve replacing the damaged area with new plywood or repairing the existing plywood.

5. Install new planks: Once the subfloor has been repaired, you can install new planks. Use a flooring adhesive to attach the planks to the subfloor. Make sure to stagger the joints between the planks and use a spacer to ensure that the planks are properly spaced.

6. Sand and finish the floor: Once the new planks have been installed, you need to sand and finish the floor. Use a sander to smooth out the floor and remove any gaps between the planks. Then, apply a finish to the floor to protect it from water damage.

By following these steps, you can repair engineered wood floor water damage and restore your floor to its original condition.